![]() Once the plate is firmly screwed into your TV, you can attach it to the hanging mount. Notice that these types of mounts have a swivel mechanism on their back, allowing the TV to tilt once it’s mounted. If the screws are too long for the sockets, use washers to secure them in place. Screw the TV plate onto the back of your TV, making sure that the screws fit snugly into the sockets. ![]() Place the pole at the height you want your TV to be, and secure the pole in place using two bolts. Ensure that the wire is correctly placed inside the second pole. Make sure the plastic collar is around the second pole piece before sliding it into the first one. You can also plug the TV normally, though consider that the hanging wire may be distracting. If you want to fish the TV’s wires up the pole and through the ceiling, make sure to do so before proceeding to the next steps. Ensure it’s tight so that it can hold the weight of your TV! Secure the pole to the mounting plate using a bolt. Twist it so the bolts sit inside the plate’s brackets and drill the bolts tightly into your ceiling. Make sure you’re precise, so you don’t accidentally drill misplaced holes into your ceiling.ĭrill the bolts into your ceiling, leaving enough of the bolt hanging out so you can slide on your mounting plate. Once you’ve planned where to place your TV mount, put the mounting plate flush against the wall and use a pencil to mark where you’ll drill the bolts. As the name indicates, you can tilt and swivel the TV once mounted, allowing you to tilt it down towards your bed if you want to watch something lying down.Ĭlick the image for more info How to install a Tilt and Swivel TV Mount? 1/ Tilt and Swivel MountĪ tilt and swivel mount hangs your TV from the ceiling using a pole. You can either use a tilt and swivel mount, a swing arm mount, or a motorized mount. You have some flexibility when mounting a TV to a ceiling. You have three options when mounting a TV to a ceiling. Experiment with the height before you drill into your ceiling, and know that you can always adjust it later if you need to. Ultimately, you’ll want it to be at least 109 centimeters (47 inches) above your bed so you won’t hit your head, but you may need it to be higher, depending on your height. Just make sure it can be shortened if needed. If you’re worried about the TV mount being too short, opt for a longer model. This problem can be solved by roughly measuring from your ceiling until your approximate eye level. However, you may be stuck with a TV that’s placed too high if the mount does not extend far down enough for you to see. Most TV tilt and swivel mounts are adjustable, so you can tweak the height once it’s installed. You want to make sure that you can see the TV when sitting up and lying down. If you have very tall ceilings, you must ensure you buy a TV mount that extends long enough so you can comfortably watch TV without titling up your head.Īlthough determining your eye level isn’t an exact science, it’s essential when mounting a TV over your bed. ![]() You may also want to consider the interior design of your room, as a low-hanging TV will be the space’s focal point. You want to ensure you can comfortably get in and out of your bed without hitting your head on the TV. Be aware of how high your bed is and your eye level. Although you can apply this same rule to mounting a TV above a bed, there are other factors to consider. When mounting a TV to a wall, it’s usually recommended to mount it about 109 centimeters (or 47 inches) from the floor. How high a TV should be mounted over a bed depends.
0 Comments
Leave a Reply. |